Need some quick instruction for your Baofeng UV5R?
Here is a quick summary of how to program that HT for simplex and repeater operation. Thanks to K2COE for the information!
Simplex:
1 - On the upper display, in VFO mode,
set the desired frequency
2 - MENU -> 25 -> MENU, set SHIFT-D to OFF using
the UP/DOWN keys, MENU, EXIT
3 - use PTT to send
4 - to save as a channel, delete the channel 1st:
MENU -> 29 -> MENU, enter channel#, MENU -> EXIT
5 - MENU -> 27 -> MENU, enter channel#, MENU -> EXIT
Duplex/repeater:
1 - On the upper display, in VFO mode,
set the desired frequency
2 - MENU -> 13 -> MENU, enter PL/CTSS Tone, if any
or OFF, MENU -> EXIT
OR, if the repeater uses DCS code, MENU -> 12 -> MENU,
use up/down keys to select the DXXXX code,
or OFF, MENU -> EXIT
3 - MENU -> 25 -> MENU, set SHIFT-D to + or -,
MENU -> EXIT
4 - MENU -> 26 -> MENU, enter repeater offset: usually
000.600 for 2m, 005.00 for 70cm MENU -> EXIT
5 - to save as a channel, delete the channel 1st:
MENU -> 29 -> MENU, enter channel#, MENU -> EXIT
6 - MENU -> 27 -> MENU, enter channel#, MENU -> EXIT
7 - press SCAN to calculate TX frequency
MENU -> 27 -> MENU (wait for beep) MENU -> EXIT
8 - Verify in channel mode: select channel, press SCAN to
display TX frequency.